colt banner

Author Topic: Removing Cylinder Engraving  (Read 1081 times)

Offline Rcampb6131

  • Newbie
  • *
  • Posts: 41
  • Newbie
    • View Profile
Removing Cylinder Engraving
« on: December 31, 2016, 12:55:39 PM »
Have any of you removed the engraving from a Leech & Rigdon cylinder, and if so, how did you do it?  Did the cylinder still function correctly afterward?



Offline sltm1

  • Sr. Member
  • ****
  • Posts: 292
  • Newbie
    • View Profile
Re: Removing Cylinder Engraving
« Reply #1 on: December 31, 2016, 01:16:08 PM »
I would mount it on an arbor and spin it on a lathe using a file to remove the engraving. However, I don't know what the thickness of the metal is on the outside of the chambers and if you go too far you'll weaken the walls.