Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mazo kid

Pages: [1] 2 3 ... 6
Leech & Rigdon / Re: USPS - Beware!!
« on: October 07, 2020, 08:51:06 AM »
Recently I shipped a pistol (non-gun!) to NJ by Priority mail. It was supposed to be there in 3 days, but took 9 days. I have had several sent and received with no problem, but with the added load on Postal Service these days,  I'm sure there will be some delays for some.

Hewy, the photos are in the next thread down.

Introductions / Re: New Member Kim Hyatt
« on: August 18, 2020, 01:31:53 PM »
Welcome from Wisconsin!

General Discussion / Re: using filler in your loads
« on: August 08, 2020, 05:04:57 PM »
I'm with Dave on not using filler. Yeah, I know it has been said that bringing the ball close to the end of the cylinder improves accuracy. I have never seen it happen.

Starr DA and SA / Re: A Starr
« on: July 29, 2020, 12:11:53 PM »
I would like that!

Belly guns and Snubbies / Re: Another kit snubbie
« on: July 26, 2020, 03:10:13 PM »
When I said kit snubbie, I mean I built it from a full size kit

Belly guns and Snubbies / Re: Another kit snubbie
« on: July 26, 2020, 01:40:30 PM »
I altered the grip frame using 1/8" brass stock, made the grips from home-grown walnut.

Belly guns and Snubbies / Another kit snubbie
« on: July 26, 2020, 01:37:49 PM »
This is a Navy, lots of fun to shoot.

Stainless Steel Replicas / Re: A NAA 22
« on: July 24, 2020, 05:54:58 PM »
ASM, yes as far as I know. My gun didn't come with the factory powder dipper, so I cut a 22 case down, a bit at a time, to dispense the ffffg powder.

I got the knife off the trade blanket of a rendezvous friend.

Belly guns and Snubbies / Re: Made from a kit
« on: July 24, 2020, 05:28:45 PM »
Jim, I am normally an HC type of guy but I just thought I would try something different. This kit was an earlier one where the only finished pieces were the cylinder and barrel. The frame had milling marks and the brass needed filing and polishing. It was truly a learning experience!

Belly guns and Snubbies / Made from a kit
« on: July 24, 2020, 01:16:22 PM »
I had an unfinished kit gun and wanted to make something different. This is what I came up with. Took a perfectly good new gun and chopped it up!

Stainless Steel Replicas / Re: A NAA 22
« on: July 24, 2020, 01:00:11 PM »
This is the simple box I use to store the gun and accessories. I made the set of "boot" grips as the factory grips are hard to hang on to!

Stainless Steel Replicas / A NAA 22
« on: July 24, 2020, 12:57:18 PM »
I picked this little guy up a while back, bought a second cylinder shortly after that.

Pages: [1] 2 3 ... 6